Home » 2011-2023 6.7L Ford powerstroke 4" DPF Delete Pipe SuperDuty Exhaust

Compatibility: 2011–2023 Ford Super Duty F-250 / F-350 (6.7L Powerstroke)

Product: 4" DPF Delete Performance Exhaust System

LEGAL DISCLAIMER & COMPLIANCE

OFF-ROAD USE ONLY: This high-performance racing component is engineered exclusively for competition or sanctioned off-road use. It does not comply with federal or local emissions laws for highway operation. Installation on any vehicle registered for public roads is strictly prohibited. The end-user assumes all legal liability and risk associated with the installation and use of this product.

PHASE 1: DISASSEMBLY & OEM REMOVAL

Step 1: Exhaust System Detachment Begin the disassembly of the OEM exhaust system at the factory downpipe. Unscrew the primary flange connection and loosen the heavy-duty clamp located at the rear of the Diesel Particulate Filter (DPF) assembly.

Step 2: DPF Extraction

  1. Disconnect all sensors and auxiliary lines from the DPF unit. Secure the vehicle’s sensor harnesses safely to the chassis to prevent heat damage.

  2. Lubricate the metal hangers with a silicone-based spray or WD-40, then extract them from the OEM rubber isolators.

  3. Carefully remove the factory DPF unit from the truck.

PHASE 2: COMPONENT INSTALLATION

Step 3: Primary Pipe Placement Align the #1 Delete Pipe with the flanged outlet of the factory downpipe. Secure the flange connection loosely with the hardware to allow for later adjustment.

Step 4: Intermediate Pipe Integration Install the #2 Pipe into the assembly:

  1. Insert the integrated metal hanger into the corresponding OEM rubber mount.

  2. Align the rear flange of Pipe #1 with the front flange of Pipe #2 and secure them with the provided bolts. Leave the hardware finger-tight for now.

PHASE 3: FINAL ALIGNMENT & TORQUE

Step 5: System Calibration & Securing With the system loosely assembled, perform a final visual inspection to ensure proper clearance from the frame, suspension, and cables.

  1. Adjust the pipes to achieve a level, professional appearance and optimal chassis clearance.

  2. Torque Sequence: Tighten all flanges and clamps evenly, starting from the front flange connection and proceeding systematically to the rear.

POST-INSTALLATION ADVISORY

  • ECM Tuning: This hardware modification requires a compatible Electronic Calibration (Race Tune) to disable the factory emissions logic. Failure to update the software will cause the vehicle to enter "Limp Mode."

  • Maintenance: Re-torque all hardware and check for exhaust leaks after the first 50–100 miles of driving to account for thermal expansion and material settling.